Search results for " DC-DC converter"

Adaptive tuning system and parameter estimation of a digitally controlled boost converter with STM32

2019

. This paper proposes a diagnostic system of a power electronic converter, based on a cheap STM32 Nucleo board, aiming to extract some relevant measurements which gives back important values of the converter's parameters behavior. Moreover the designed system is also exploited for implementing the converter's auto tuning in order to optimize its dynamic performance.

A High-Efficiency, Low-Cost Solution for On-Board Power Converters

2012

Wide-input, low-voltage, and high-current applications are addressed. A single-ended isolated topology which improves the power efficiency, reduces both switching and conduction losses, and heavily lowers the system cost is presented. During each switching cycle, the transformer core reset is provided. The traditional tradeoff between the maximum allowable duty-cycle and the reset voltage is avoided and the off-voltage of active switches is clamped to the input voltage. Therefore, the system cost is heavily reduced and the converter is well suited for wide-input applications. Zero-voltage switching is achieved for active switches, and the power efficiency is greatly improved. In the output …

A Model of DC-DC Converter with Switched-Capacitor Structure for Electric Vehicle Applications

2022

In this paper, a DC-DC converter with an innovative topology for automotive applications is proposed. The goal of the presented power converter is the electrical storage system management of an electric vehicle (EV). The presented converter is specifically compliant with a 400 V battery, which represents the high-voltage primary source of the system. This topology is also able to act as a bidirectional power converter, so that in this case, the output section is an active stage, which is able to provide power as, for example, in the case of a low-voltage battery or a supercapacitor. The proposed topology can behave either in step-down or in step-up mode, presenting in both cases a high gain…

Dynamic performance evaluation of a non linear digital control technique for multiphase VRMs

2010

DC-DC Converter for Photovoltaic Application with MPPT function embedded interleaved 4

2012

We present a DC-DC converter for photovoltaic (PV) applications that is suitable for a distributed power conversion approach, obtained by transferring part of the electronics from the inverter to the module. The proposed circuit is a high-efficiency four-phase interleaved boost converter employing relatively low-valued inductive and capacitive components. Its realization is made possible thanks to the design of a dedicated integrated circuit (IC) performing the converter control section as well as the Maximum Power Point Tracking (MPPT) algorithm. The solution is designed for a maximum delivered power of 300 W and to work with MPPT voltage between 9 V and 40 V, with maximum allowed panel cu…